If you’re searching metal board and batten siding near me, you’re after the tall vertical look of a classic farmhouse wall without the scraping, caulking, and repainting that wood demands. Board & Batten is one of our standard wall panel profiles, and it’s a straight swap for the wood version at a fraction of the upkeep.

Here’s what the profile is, what the finishes look like, and why where you buy it changes what you get.

What the profile is

Board and batten alternates a wide flat board with a raised narrow batten covering the seam. In wood, the batten is a separate strip nailed over the joint. In steel, the profile is roll-formed into the panel itself, so the batten is part of the panel rather than something that can work loose.

It runs vertically, which sheds water fast and reads taller than horizontal lap siding. That’s why it’s showed up on so many modern farmhouse and barndominium exteriors. Our guide to vertical metal siding covers how the vertical profiles compare, and modern farmhouse metal siding gets into the design pairings.

Finishes: solid colors and wood-look prints

You’ve got two directions. There are 44 plus solid colors if you want the panel to read as a painted wall. Or there are the wood-look prints, which are where board and batten gets interesting: Smooth Cedar, Barnwood, Rough Cedar Gray, Burnt Wood Charcoal, Burnt Wood Black, Chippy White, Walnut, Pecky Cypress, Primitive Pine Plank, and Gray Wash Barnwood.

A wood-look board and batten wall gives you the grain and the profile together, and it doesn’t gray out, cup, or need a coat of stain every few years. For how the finishes hold up on a house specifically, see steel siding for houses.

Why searching metal board and batten siding near me is worth doing

Buying from whoever runs the roll-former gets you three things a shelf can’t. Panels come formed to your wall height, so you’re not lapping mid-wall. Trim gets formed in the same finish off the same coil, which matters a lot on a profile with this many visible edges. And freight stays sane, which on a bulky wall panel is a real line item.

There’s a Pacific Northwest angle too. Steel siding is non combustible, and after the last few fire seasons around Spokane and Coeur d’Alene that’s moved from a nice-to-have to a reason people call. Our piece on non combustible siding covers how the materials compare, and the Metal Construction Association is a neutral reference on wall panel systems.

Common questions

Can metal board and batten go over existing siding?

Sometimes, depending on what’s under it and whether the wall is flat and sound. It’s a question for whoever’s installing, and the honest answer usually involves looking at the wall first.

What gauge should I use on a wall?

Walls don’t take the foot traffic or snow load a roof does, so wall panels can run lighter than roof panels. We roll 24 and 26 gauge. Tell us the building and we’ll tell you what makes sense.

Does the trim have to match?

It should. Corners, J-channel, and transitions are the most visible parts of a board and batten wall, and mismatched trim is what makes a good panel look cheap. We form trim to match the panel finish, and metal trim runs through every piece.

The bottom line

Metal board and batten gives you the farmhouse profile in a material that doesn’t rot, burn, or need repainting, and the wood-look prints mean you don’t give up the grain to get there.

We roll-form in Post Falls, Idaho and ship across Idaho, Washington, Oregon, and Montana. Give us a call with your wall dimensions, or ask for free samples if you want to see Smooth Cedar and Barnwood side by side before you commit.